Wilshire@sh.itjust.works to Nature and Gardening@beehaw.org · 1 year agoMy 3D printed succulent planters.sh.itjust.worksimagemessage-square23fedilinkarrow-up1151arrow-down10
arrow-up1151arrow-down1imageMy 3D printed succulent planters.sh.itjust.worksWilshire@sh.itjust.works to Nature and Gardening@beehaw.org · 1 year agomessage-square23fedilink
minus-squareWilshire@sh.itjust.worksOPlinkfedilinkarrow-up2·1 year agoI use higher temps, 2mm layer height, 0.6mm line width, and 0.4mm nozzle. I find that going higher than 150% has an effect on my surface quality.
minus-squareHaatveit@beehaw.orglinkfedilinkarrow-up2·1 year agoTrue, it does affect surface quality a bit, but I found that for some uses, it’s was actually desirable or at least tolerable
I use higher temps, 2mm layer height, 0.6mm line width, and 0.4mm nozzle. I find that going higher than 150% has an effect on my surface quality.
True, it does affect surface quality a bit, but I found that for some uses, it’s was actually desirable or at least tolerable