minus-squareandreyk0@discuss.tchncs.deOPtoAsk Electronics@discuss.tchncs.de•Siglent SDS1104XE: slanted square wavelinkfedilinkEnglisharrow-up1·1 year agoThanks but unfortunately this is not a probe cal problem. Note that the issue is seen even in a 50Ohm environment, no probes. linkfedilink
andreyk0@discuss.tchncs.de to Ask Electronics@discuss.tchncs.deEnglish · edit-21 year agoSiglent SDS1104XE: slanted square waveplus-squareimgur.comexternal-linkmessage-square2fedilinkarrow-up13arrow-down10
arrow-up13arrow-down1external-linkSiglent SDS1104XE: slanted square waveplus-squareimgur.comandreyk0@discuss.tchncs.de to Ask Electronics@discuss.tchncs.deEnglish · edit-21 year agomessage-square2fedilink
minus-squareandreyk0@discuss.tchncs.detoAsk Electronics@discuss.tchncs.de•How to remove press fit connectorslinkfedilinkEnglisharrow-up4·1 year agoI’d try deoxit first. If that fails, one pin at a time is a lot of work but doable linkfedilink
Thanks but unfortunately this is not a probe cal problem. Note that the issue is seen even in a 50Ohm environment, no probes.