Fpm101 build by Sadek Baroudi (fingerpunch kb), case designed and 3D printed by me. It uses keyboardio key caps and has matias clicky alps clones. It has a scroll ring around the trackball also!
Can’t wait to use lemmy!
If you don’t mind sharing, how much did this cost to build?
Well, that’s a bit hard to nail down, the board is not for sale yet so, I’m not sure the price is nailed down. The plate is laser cut acrylic I got on special from elecrow for $4. The Keboardio keycaps were on sale for $5 a set for the alps version. I went cheap and got Matias clicky switches (alps clones), $40 for 200. I also used half a roll of filament for the case, about $20, and screws I had on hand. All in, disregarding prototype cases, around $280 to $300.
Looks like something from Stargate SG1
Was about to comment “are you Goa’uld?” when I saw this.
Your sense for aesthetics are always on point. 🔥
I like the style, everything about it looks well thought out and put together. What scroll ring is used on this, and where did you get it?
It’s a PERS56. You can get them at DigiKey or mouser. I forget if it’s one or both!
