Hello folks! I have these switches in my bathroom.

The rightmost is the lights, and the middle one is the bathroom fan, and I’d like to replace that middle one with something I could load tasmota on (or some other open source firmware), without replacing the other switch, the sockets, or the faceplate.

I haven’t seen any smart switches that have a form factor that would fit through this faceplate, though; they seem to mostly want to be the entire electrical box.

If it weren’t for the electrical plugs I could maybe replace this with some kind of 2-gang thing, which isn’t really what I want but could be fine, but as it stands I’m not sure what my options here are.

I don’t need the new switch to necessarily look like the old one, I just want it to fit in the same box and use the same faceplate. Do you folks have any recommendations?

  • psycotica0@lemmy.caOPEnglish
    8·
    11 months ago

    You know… I hadn’t even noticed that outlet wasn’t GFCI… Ha!

    Ok, you (and everyone else in thread) are right, the idea of rewiring the whole box wasn’t appealing to me, but if I’m being objective it’s actually not that much work and is probably less money overall than the smart switch itself.

    Thanks folks, for shaking the blinders off me!

    • hi_its_me@lemmy.worldEnglish
      2·
      11 months ago

      It could be down the line from another GFCI receptacle and still be protected. You can use a tester to trip it and see.