I’m aware that Leah strongly discourages using CH341a, but I understand that this is chiefly because it’s voltage is 5V, whiich risks burning the 1.8V or 3.3V datalines of the devices we’re librebooting.

At the same time, I’ve seen a popular video specifically recommending CH341a when librebooting an X200. I assume this advice should be ignored.

However, Leah also specifies that you can technically tweak the CH341a to reduce it’s voltage, following this guidance.

My question is: is this worth it, or is it safer to just use a Beaglebone Black/Raspbery Pi instead? What’s your experience been?

I’m unfortunately on a budget, and BB/RPi are both prohibitively expensive for me. Then again, so is a laptop that’s bricked thanks to an improperly fixed CH341a.

Have you had problems using a (tweaked or untweaked) CH341a? What’s your advice? I really appreciate it. Thanks!

  • automaticdoor75
    link
    fedilink
    arrow-up
    2
    ·
    1 year ago

    I’ve had zero luck with external flashing. I’ve tried the CH341A programmer and a Raspberry Pi to flash an X200, haven’t gotten it to work. If you’re referring to the Wolfgang video, I followed that video as close as I could, but it didn’t work.