A sticker.
I was going to say unplug it, then plug it back in. But I think you got the correct answer right out of the gate.way
So, to be able to transmit packets wirelessly, it needs a medium to communicate them over. If you stick it in the microwave for a while, it should begin to absorb the microwave radiation. Once it’s full enough (minimum 20 minutes in microwave, recommend full hour if you have the time), it should then start emitting excess microwave radiation that your devices can pick up, and then you can check your e-mail.
Unplug all the wires. Now it’s wireless!
Just plug a WiFi cable and you’re done.
This made me laugh out loud, thank you.
They are on sale for just 1.95/pc ! https://www.kinkerlitzchen.de/wlan-kabel/scherzartikel_56284769_5857
Suitable for
ApplePear,WindowsDoors andLinuxParrots.Platform agnostic hardware, nice.
Drill a hole through it to let the signals escape.
Make it wireless by cutting all the cables.
You need to leave about 15 cm of each internet cable to act as antennae.
Cut the blue wire, strip it back to the rj45 plug, and then untwist the 4 wire pairs shaping them into antenna. Works every time. You will get signal for 2 city blocks. I promise.
On the phone you used to take the photo, turn on the personal hotspot.
No
Just open wifi settings on any device you have connected here & connect to your neighbours wifi.
Put it high up in your attic, it’ll sense the elevation and start broadcasting
You’re going to need a radioactive isotope. I like cobalt-60 but caesium-137 can work too. Boil it into a tea. Plug one end of a patch cable in to port #6 and dip the other end into the nuke tea. Heavier isotopes give you more speed but less range, that’s why I like the cobalt-60. It can punch through building materials pretty good so no dead zones.
It just needs more power so the internet waves come out of it, try connecting it directly to the power lines outside your house so the pesky transformer doesn’t get in the way
There are already some good tips in the comments, but do not forget to remove the RF shielding inside.
Plug a laptop into it and enable the wifi Hotspot feature. Works well on windows/Fedora
Instructions unclear
Where to I point the heat gun to create the hotspot?
The hotspot is usually in the battery, so point the heat gun towards it. You know you have better wifi if the cells puff up
Did you check the WiFi fluid level?
I just topped it off, but I substituted Gamer Juice for the brand label, is that a problem?
